🇬🇧

Know How

What is an FEM calculation?#

The finite element method (FEM) calculates the behavior of a structure using a model made up of connected elements and nodes. It is also suitable for systems whose support forces cannot be determined from force and moment equilibrium alone. The result describes the calculation model with its entered data and boundary conditions; it is not automatically a complete assessment of the real setup.

Equilibrium and stiffness#

For a statically determinate system, support forces can in simple cases be determined from the equilibrium conditions alone. The image shows a beam with two supports and several point loads. For this particular support arrangement, the equilibrium conditions are sufficient to determine the support forces.

Simply supported beam with two supports and example point loads

Idealized example of a statically determinate system.

In a statically indeterminate system, there are more unknown support forces than independent equilibrium conditions. The stiffness and deformation compatibility of the system must also be taken into account.

Continuous beam with three supports and example point loads

Idealized example of a statically indeterminate system. The number of supports alone is not a general criterion for static determinacy; the restrained movements and stability of the model also matter.

A hand calculation can show equilibrium and deformations transparently for simple models. For complex structures, hand calculations quickly become extensive. FEM solves a single system of equations that links model stiffness, displacements, and forces. For linear-elastic systems, this is often abbreviated as K · u = F: K is the stiffness matrix, u the unknown displacements and rotations, and F the assumed forces and moments.

For linear behavior and the same boundary conditions, individual load cases can be superimposed. This assumption does not apply without limitation, for example when support conditions change, elements that carry tension only or compression only fail, or second-order effects are considered.

The beam model in Production Assist#

Production Assist models the load-bearing structural members used in static calculation as three-dimensional beam elements. An element connects two nodes. At each node, the model can account for displacements in three directions and rotations about three axes. Material and cross-section data determine the element's stiffness; supports, hinges, and loads define further model conditions.

The calculated deformation state is used to determine, among other things, support reactions and internal forces such as axial force, shear forces, torsion, and bending moments. The subsequent assessment compares the results with the cross-section and material data stored in the model and the enabled verifications.

A beam model does not represent every detail of a real component. In particular, element results do not provide a separate local verification of welds, bolts, or other connection details. Stability, supports, connections, and the suitability of the data used must also be assessed for the specific setup. For a general introduction to reviewing results, see Static Calculations; this overview of structural systems explains the terms statically determinate and indeterminate.

Check the calculation and its results#

  1. Model all structural members and connections relevant to the calculation. Check whether the selected supports restrain the movements that are actually restrained in the real setup.
  2. Check the material and cross-section data stored in the model, as well as all loads and load groups.
  3. Check the active load combinations and verifications. The Second-Order Calculation / ΔP Method option affects the calculation of internal forces; information about the settings is available under Static Calculations.
  4. If needed, start Rigging → Calculate Statics. If real-time calculation is enabled, Production Assist recalculates automatically after model changes that affect the calculation.
  5. After the calculation, check the status, messages, combinations used, and results for the relevant structural members and supports. A successful solver run alone does not confirm that every member or connection has been fully verified.

The guide Static Calculations describes the exact procedure, calculation scope, and result views. A software calculation does not replace any required external review, approval, or professional assessment.